n

The

utility is a server that converts

program numbers into universal addresses. It must be running on the host to be able to make

calls on a server on that machine.

When an

service is started, it tells

the address at which it is listening, and the

program numbers it is prepared to serve. When a client wishes to make an

call to a given program number, it first contacts

on the server machine to determine the address where

requests should be sent.

The

utility should be started before any other RPC service. Normally, standard

servers are started by port monitors, so

must be started before port monitors are invoked.

When

is started, it checks that certain name-to-address translation-calls function correctly. If they fail, the network configuration databases may be corrupt. Since

services cannot function correctly in this situation,

reports the condition and terminates.

The

utility can only be started by the super-user.

When debugging

do an abort on errors.

Run in debug mode. In this mode,

will log additional information during operation, and will abort on certain errors if

is also specified. With this option, the name-to-address translation consistency checks are shown in detail.

Do not fork and become a background process.

Specify specific IP addresses to bind to for UDP requests. This option may be specified multiple times and is typically necessary when running on a multi-homed host. If no

option is specified,

will bind to

which could lead to problems on a multi-homed host due to

returning a UDP packet from a different IP address than it was sent to. Note that when specifying IP addresses with

will automatically add

and if IPv6 is enabled,

to the list.

mode. Allow calls to SET and UNSET from any host. Normally

accepts these requests only from the loopback interface for security reasons. This change is necessary for programs that were compiled with earlier versions of the rpc library and do not make those requests using the loopback interface.

Turn on libwrap connection logging.

Cause

to change to the user daemon as soon as possible. This causes

to use non-privileged ports for outgoing connections, preventing non-privileged clients from using

to connect to services from a privileged port.

Cause

to do a "warm start" by read a state file when

starts up. The state file is created when

terminates.

Turn on remote calls. Cause

to open up random listening ports. Note that rpcinfo need this feature turned on for work properly. (This flag is a Debian extension.)

If "/etc/default/rpcbind" exists, rpcbind will use the specified options at launch time

Otherwise rpcbind will try to load configuration from "/etc/rppcbind.conf"

The default options are set as "-w -f".

All RPC servers must be restarted if

is restarted.

Aurelien Charbon <aurelien.charbon@bull.net>